$350.00

These are for the LED boards ONLY! This is NOT a plug and play kit. You will need to do some work to install them.

***Please allow up to 10 weeks for delivery***

The new boards are shaped to the factory lens and will need to be glued to the lens. We recommend a simple silicone sealant placed 4-5 times around the perimeter. 

These will also need some changes to your current wiring, but they're not that difficult.

The stock wiring is Turn/ brake and parking light... just 2 wires.

You will need to run 3 additional wires... ignition power, separate brake wire, and a ground.

The ignition power is a switched 12V + wire that is "hot" when the key is turned on, and it is "cold" when the key is turned off.

The brake switch wire needs to be changed right at the brake switch, located under the dash and at the steering column/ brake pedal mount. There are two wires on that switch. One is always "hot" 12V +. The other wire is the "cold" side and rests with no power on it. Once the brake pedal is pressed it will go to 12V +. Unplug this wire from the brake switch and extend it to the tail lights with your new ignition wire.

Back at the tail light, you can get a ground wire connection pretty much anywhere on the sheet metal of the truck with the tail light removed.

So your wiring at each tail light will be... ignition +, ground, turn (right of left depending on which side you're on), brake, and running light.

The boards will come with lengths of wire attached. Connection is up to you.

 

 

Current Stock:
Shipping Cost:
Calculated at Checkout

No Reviews Write a Review